English
Which USB is right for your application? (Part 3)
Dan Harmon, Texas Instruments
EETimes (4/8/2012 8:29 AM EDT)
In 2007, I wrote a two-part series titled “Which USB is Right for your Application” for Planet Analog. Since then, several new and different “versions” of USB have been released. In this article, I discuss how they have been deployed in the market in the almost five years since.
Also, I address SuperSpeed USB (USB 3.0) and its impact on the USB market. I would also be remiss if I do not address Thunderbolt™ Technology as well and its impact on PC interfaces moving towards the future.
We will close this article by discussing some recently announced new initiatives from the USB-IF aimed to enhance the end consumer experience with USB.
|
E-mail This Article | 
|
|
Printer-Friendly Page |
|
||||||
Related Articles
- Which USB is Right for Your Application? (Part 2)
- Which version of USB is right for your application? (Part 1)
- Is a single-chip SOC processor right for your embedded project?
- Viewpoint -- USB 3.0: Not just for wired apps
- Overcome signal attenuation, noise and jitter interference challenges in USB 3.0 system design
New Articles
- Accelerating RISC-V development with Tessent UltraSight-V
- Automotive Ethernet Security Using MACsec
- What is JESD204C? A quick glance at the standard
- Optimizing Power Efficiency in SOC with PVT Sensor-Assisted DVFS Technology
- Bandgap Reference (BGR) Circuit Design and Transient Analysis in 90nm VLSI Technology
Most Popular
- System Verilog Assertions Simplified
- Accelerating RISC-V development with Tessent UltraSight-V
- System Verilog Macro: A Powerful Feature for Design Verification Projects
- Understanding Logic Equivalence Check (LEC) Flow and Its Challenges and Proposed Solution
- Design Rule Checks (DRC) - A Practical View for 28nm Technology