LVDS RX PHY & Controller

Innosilicon LVDS implements LVDS TIA/EIA protocol. It specifies a low-voltage point-to-point signal interface, which uses a differential driver connected to a terminated receiver through a constant-impedance transmission line. Normally, Innosilicon LVDS contains serial-to-parallel logic, PLL and register bank. It can be configured by registers through APB bus.
In addition, Innosilicon LVDS could extend from 5 lanes to N lanes (N is required by the customer). Therefore, the TTL lines extend respectively.

• see the entire LVDS RX PHY & Controller datasheet
• get in contact with LVDS RX PHY & Controller Supplier