-

Low-Noise Amplifier 10-15GHz

The WEA7681L22G is an integrated low-noise amplifier with Gain Control block designed for Automotive Radar and mm-Wave Wireless Phase Arrays receiver applications. The WEA7681L22G operates between ...

The WEA2630L45G is an integrated low-noise amplifier designed for Microwave Backhaul,5G Communications and mm-Wave Wireless Phase Arrays receiver applications. The WEA2630L45G operates between ...

-

-

Low-Noise Regulator, 15mA, 1.2V - GlobalFoundries 55nm

Low-Noise Regulator, 40mA, 1.2V - GlobalFoundries 55nm

Low-Noise Regulator, 5mA, 1.2V - GlobalFoundries 55nm

Low-Noise Regulator, NMOS, By-Pass Mode, 15mA, 1.2V - STMicroelectronics 65nm

Low-Noise Regulator, NMOS, By-Pass Mode, 40mA, 1.2V - STMicroelectronics 65nm

Low-Noise Regulator, NMOS, By-Pass Mode, 5mA, 1.2V - STMicroelectronics 65nm

Low-Noise Regulator, Tunable, 1.2V - GlobalFoundries 40nm

Low-Noise Amplifier (Single-ended cascode) - GlobalFoundries 22nm

180TSMC_LNA_08 a low noise amplifier (LNA) is usually used as the first stage of receivers and is characterized by low noise figure and high linearity. LNA consists of two stages. The first ...

Noise @ 1MHz offset=2.5nV/Sqrt(Hz), IDD=12mA

Low noise amplifier (LNA) is usually used as the first stage of receivers and is characterized by low noise figure and high linearity. The structure is based on two matched cascades. The first ...

LNA is consists of two bipolar amplifier stages. The block used correction circuit for extension frequency range. Amplifier output based on common collector circuit for low output impedance. ...

This macro-cell is a low noise, high PSRR voltage reference core designed for TSMC 0.18μm (CLM18) CMOS technology. The core is ideal for applications where noise performance is critical. The ...

Low-noise bandgap reference

The PVOA201LN is a low power, low noise, fully-differential op amp with a rail-to-rail output and an input common-mode range including the negative power supply rail. This amplifier is an ideal ...

The AXIOM_PULLFIRDAC is a high accuracy sigmadelta digital-to-analog converter. The low out-of-bandnoise (OOBN) down to -60dBFS makes the converter ideally suited for application with strict ...

055TSMC_LNA_01 is an electronic amplifier intended to amplify a very low power signal without significantly degrading its SNR. The operating frequency range from 500 to 1750MHz is achieved using ...

055TSMC_LNA_02 is an electronic amplifier intended to amplify a very low power signal without significantly degrading its SNR. The operating frequency range from 25 to 500MHz is achieved using ...

350AMS_LNA_04 is a common receiver front-end device which is used to provide impedance matching to off-chip circuits and to perform first step low noise amplification to overcome noise of subsequent ...

This DCDC IP is a high efficiency PWM step-down DC/DC converter IP, with fast transient response and accurate regulation. Both the main (P-Channel MOSFET) and synchronous (N-Channel MOSFET) ...

Mobile radio communication is trending towards complex multi-radio systems comprising of several transceivers. The MIPI RFFE bus is is 2-wire serial interface which utilizes a bus frequency ...

The RFFE Slave IP Core is Compliant with MIPI RFFE Specification 1.00, it typically resides in the RFIC in a mobile platform, and utilizes the RFFE bus to identify, program and monitor the registers ...

Mobile radio communication systems are complex multi-radio systems comprising several transceivers. Arasan supports the latest MIPI RFFE standard v3.0. The RFFE bus is a 2-wire serial interface ...

Mobile radio communication is trending towards complex multi-radio systems comprising several transceivers. Arasan supports the latest MIPI RFFE standard v3.0 controller IP. The MIPI RFFE bus ...

This satellite tuner is a direct-conversion (zero IF) receiver for digital TV Broadcasting. On the RF input, there is a variable gain, low-noise amplifier (VGLNA). The RF gain is monitored by ...

-

YANZI-A-hexCOD-MT1-LR-VD.02 is a high-performance audio CODEC with 6 analog-to-digital converters (ADC) ensuring the most precise far-field vocal recognition with minimum phase mismatch, an ...

180TSMC_LNA_14 is a IP block which includes a low-noise amplifier (LNA), gain control system and supply voltage controller. The low-noise amplifier is intended to amplify wideband high-frequency ...

1-VIA’s VSCOM4l400ABG IP is a 1.8V low-noise unbuffered programmable 0.6 and 0.8V Bandgap Voltage References (BGR) with eight 50μA reference output currents implemented in TSMC12/16nm CMOS ...

The ANLBPLL0100 is an integer-N PLL for frequency synthesis that can be used to create a low phase-noise local oscillator (LO) for applications operating in the L band (1 GHz – 2 GHz). The ...

The TRV701TSM40LP IP is a 1.8V low-power low-noise programmable 0.55V Band-Gap Reference implemented in TSMC Low-Power 40nm CMOS process technology. Its low noise and high-precision makes it ...

AD16BSAR5M40LP is a 16-bit Successive Approximation Analog-to-Digital Converter (ADC) that operates up to 5MS/s. The ADC achieves full 16bit linearity, thanks to an in-built calibration engine ...

The IQonIC Works ISP is an integrated ASIC design platform for low power analog/mixed signal ASICs for IoT, Smart Home, Healthcare, Wearables, and Industrial applications that will simplify, ...

ZX-AD16BSAR5M40LP is a 16-bit Successive Approximation Analog-to-Digital Converter (ADC) that operates up to 5MS/s. The ADC achieves full 16bit linearity, thanks to an inbuilt calibration engine ...