English
You are here:
GPS-L1 GLONASS-L1/L2 Hardware IP cores
We may propose a flexible and powerful GNSS sensor hardware design. The sensor forms GPS and/or GLONASS navigation raw measurements and data using the digital samples, coming from ADC. Signals acquisition, tracking, data decoding, synchronization etc are fully implemented on hardware level. An output interface of such a device is shown below. It consists of several main fields: range [msec], Doppler frequency [Hz], carrier phase [m/sec], Signal-to-Noise rate [dB-Hz] and additional information.
View GPS-L1 GLONASS-L1/L2 Hardware IP cores full description to...
- see the entire GPS-L1 GLONASS-L1/L2 Hardware IP cores datasheet
- get in contact with GPS-L1 GLONASS-L1/L2 Hardware IP cores Supplier
GLONASS GPS IP
- GNSS (GPS, Galileo, GLONASS, Beidou3, QZSS, SBAS) Ultra-low power RF Receiver IP
- L1 GPS/Galileo/BeiDou/GLONASS and FM/VHF/UHF/L/S/DVB -T/H/SH RF Front-end
- GLONASS/GPS/Galileo/BeiDou multisystem single-band 2-channel receiver RFIC
- L1 GPS/Galileo/BeiDou/GLONASS RF Front-end
- L1 GPS/Galileo/GLONASS RF Front-end
- RF and Analog GPS/GNSS Front End for GPS, GLONASS, Galileo and Beidu